Bodywork update

Creating  aerodynamic body panels for our Digital Genius F24 race car is now underway. We used the shape conceived by students from Eastbourne Academy and Hurst College with modelling foam before starting on the individual panels.

Aluminium is a light weight metal. Much lighter than steel. We chose thin sheets of aluminium as these can be more easily bent into shape.  Each flat aluminium panel was cut to size by our metal supplier. They come coated in a thin green coloured protection film that we will remove later.

IMG_2418

Placing an aluminium panel on the chassis we check it is the right size. We then temporarily clamp the panel in place, so that it does not move, while we mark out lines to indicate where the panel needs to bend.

IMG_2424

Bending thin aluminium sheet panels does not require any complex machinery. We lay the panel on one wood pallet and place another on top where the edge of the pallet lies along the marked line. We bend the panels using our own strength being careful to make sure we are bending along the marked line. (You should where gloves for this).

IMG_2441

Some of the panels require more preparation as we need to cutout sections before we do any bending. We use a cardboard template so we can check the fit. Once we are happy with the template we can transfer the details onto the panel.

IMG_2425We lay the cardboard template on top of the panel and double check we have it correctly placed. The top edge of our template should match the top edge of the panel. We run a pen around the holes and transfer them on to the panel.

IMG_2430

To cut the panel we first drill small holes in the corner of each cutout section. These small holes need to be big enough to insert the Jigsaw blade. We then cut the remaining shape using the Jigsaw. We use a blade designed to cut metal. Normal wood cutting blades will not do.IMG_2436It takes a few minutes to cut each hole in turn. Once we have cut out all the sections, we check our work, placing the panel back on the chassis. Everything looks good. All the holes are in the right places. Now we can start bending this panel too.

IMG_2432

Currently we divided the body into five panels. Two for each side of the car plus a bonnet. We chose five because it is always best for the panels to meet at the chassis structural members. It is also easiest if each panel is not too large to handle/fit/remove.

 

Car chassis

I made this illustration showing the side of the car chassis. The drawing is 1:10 scale (so 1mm on the drawing =10mm full size).

This drawing (Adobe illustrator on Mac) helps us to understand where body panels might best be attached to the chassis and the size of each panel.  The circles with crosses in represent the centre of the wheels.

Race car panels

Screen Shot 2015-03-26 at 15.57.10